Table of Contents
Advertisement
12. Next, install the LIGHT TOWER. Position the tower arms into the
receiving pockets located on the undercarriage. Each pocket has a
lock pin that secures both light tower arms. Pull out and twist each
handle to temporarily unlock the pins. Place the light tower into the
pockets and relock the pins. See your local Blizzard dealer for com-
plete installation instructions for your vehicle undercarriage.
13. Proceed to install the PLOW HEADLIGHTS. Align one HEADLIGHT
BALL STUD MOUNT ADAPTER on the light tower tube with the
mounting hole and insert the threaded stud through each. Secure the
headlight with one 7/16" external tooth lock washer and hex nut.
Note: All snowplows are shipped with two BLACK VINYL CAPS that
install at either end of the light tower. Connect the terminals from the
plow lights to the terminals on the main lighting harness. Repeat the
installation for the opposite headlight.
14. Next, position the ROCKER SWITCH CONTROL STATION on the front
radius of the seat. Wrap the VELCRO® STRAP around the bench,
through the 2" metal D-ring and fasten. Finally, connect the white
power connector from the vehicle wire harness to the connector on
the control station. The power switch should be in the "MIDDLE" or
"OFF" position. Note: The operation of the draw latch can only be
controlled when the power switch is located in the "UP" position and
the "RAISE/LOWER" rocker switch is in the neutral or center position.
See the diagram below.
This completes the electrical assembly installation for the vehicle wire
harness and main lighting harness. You are now ready to perform all of
the test functions on the snowplow.
Power Hitch Operation
System Power OFF
System Power ON
The Power Hitch will not operate if
the Raise/Lower rocker switch is
in the "LOWER" or float position.
Vinyl
Cap
The black vinyl caps provided with your snowplow
install at each end of the light tower. Adjust the
plow headlights as desired, secure each with
hardware provided and finish the installation by
capping the light tower ends.
Electrical Assembly - Vehicle Harness (cont.)
13
Hide quick links:
Advertisement
Table of Contents
