Harmar Mobility Pinnacle Installation And Service Manual page 6

Installation Procedures
Step 7: Install rail brackets by loosening the screws and snapping each bracket edge into the slot, or slide the
brackets on from the top of the rail.
WALL
SIDE
Step 8:
A. For double rails, tighten the first rail bracket in place so, when it's turned
over, the back of the bracket touches the rear of the bottom step. Place and
tighten the second and third brackets on the steps on each side of the rail
joint, again so the back of the bracket touches the rear of the step. Place the
fourth and final bracket on the top step before the landing, again tightening
it so it touches the front of the last step.
B. Tighten the first rail bracket in place so when turned over the back of the
bracket touches the rear of the first step from the bottom landing. Place the
other rail on the last step before the top landing, again tightening it so it
touches the rear of the last step.
Step 9: Turn the rail right side up (plastic side facing up).
Step 10: Measure any obstruction from the wall (this may include handrails,
molding, light switches, etc.) and adjust the edge of the brackets an equal distance
from the wall. The edge of the track needs to be 7" from the wall or any obstruction.
6
Pinnacle HD Stair Lift Manual | | www.Harmar.com | 866-351-2776
P/N: 75403 RevB 72618