Using The Dcs-37-3 Mount (Optional) - D-Link DCS-4802E User Manual

Section 2: Installation
To mount the camera with the DCS-37-3 mount, follow the instructions below.
Step 1
Place the DCS-37-3 mounting sticker in the desired location, then use a 6 mm
drill bit to drill the required holes 25 mm deep and insert the wall anchors into
the holes. If you plan to pass cables through the wall, you will also need to drill
a hole for the cable channel.
Step 2
Use the provided screws to mount the DCS-37-3 to the wall using the inner
mounting holes.
Step 3
Remove the cover from the camera.
Pass the camera connectors through the cable channel on the DCS-37-3. Use the
provided screws to mount the camera to the DCS-37-3 using the set of mounting
holes marked B.
Step 4
Adjust the angle of the camera as desired, then put the cover back on the camera
and rotate it clockwise to lock it in place.
Step 5
Attach the camera cover.
D-Link DCS-4802E User Manual

Using the DCS-37-3 Mount (optional)

15