Section 2: Installation
Installing the Pendant Mount (Optional)
Attach the mounting plate to the bracket cap using the three included screws.
Locate a suitable position on the ceiling for a 34 mm (+2 / -0 mm) hole to be cut. Use the
included template to mark and cut the mounting holes.
Locate a suitable position on the ceiling for a 34 mm (+2 / -0 mm) hole to be cut. Use the included template to mark and cut the wiring
hole.
Drill four 6 mm holes corresponding to the holes in the mounting template and insert the plastic anchors into these holes.
Place the rubber seal between the pendant bracket and the ceiling to ensure a waterproof seal between the ceiling and the bracket.
Attach the pendant bracket to the ceiling using the screws provided.
Attach the bracket cap to the bottom of the pendant bracket by rotating the cap counterclockwise to tighten it into place.
Insert the screw into the base of the pendant bracket at the top of the bracket cap to secure the bracket cap into place.
D-Link DCS-6511 User Manual
14