Installation - Electrolux GHS605W Instruction And Installation Manual

12.
3. When all the foregoing is satisfactory, check the turndown setting on each burner, as this may
need adjustment. Valves have a by pass controlling screw, which may be accessed by
removing the knob. This screw will be located on a particular area of the valve. (Refer Figure
11). Normally, this will have been correctly set at the factory and should not require adjustment.
Please ensure the supply pressure has been checked PRIOR to any adjustment.
4. If the appliance cannot be adjusted to perform safely, inform the customer of the problem and
affix an appropriate warning notice to the appliance. If the fault appears to be dangerous the
appliance should be disconnected. If a minor fault exists, the customer may wish to use the
appliance while awaiting service.
If a fault cannot be fixed, please call the Service Centre.
5. The customer should be advised that, in the event of a fault, the local Service Organisation or
the retailer from whom the appliance was purchased should be contacted.
6. When satisfied that the unit is operating correctly, turn off and instruct the customer on correct
operation as outlined in this booklet. Ask the customer to operate the controls to ensure that
the correct procedure is understood.
Servicing must only be carried out by an authorised service person.
Injector sizes required for various gas types are shown in Table 2 (Page 10). The appliance inlet
pressure for each gas type is also shown.
For model identification after installation, an additional data plate sticker has been provided. This
sticker is to be stuck onto adjacent cabinetry.
Figure 10
Figure 11

INSTALLATION