Installation; Battery Connection; Electrical Connection; Testing Appliance Operation - Electrolux GHS605W Instruction And Installation Manual

11.

Battery Connection

The battery used is a 1.5 Volt ʻAAʼ Battery. This supplies the power for the ignition system of the
cooktop. To install, follow the instructions as shown on Figure 9 below.
NOTE:
Pay special attention to the orientation of the battery when installing.
The battery supplied is a perishable item and is not covered by the warranty.
Electrical connection (220-240 Volts)
Where applicable the appliance is supplied with a standard 10 Amp service cord terminated by a
3-pin plug for connection to a standard household socket. The electrical supply is required to
power the electronic ignition system.
NOTE:
It will be necessary for Servicing purposes to disconnect the electrical power supply.
The power point should therefore be accessible after the appliance is installed.
Diagram 1 is a schematic of the wiring in the appliance.
WEIGHT of the unit is printed on the appliance packaging label.
Diagram 1

Testing appliance operation

After installation, test the appliance and ensure that it operates correctly before handing it over to
the customer. The following procedure is recommended:
1. Turn on the gas and electricity supply (if applicable) and attempt ignition on all burners, both
separately and in combination. (For correct procedure, refer to page 3, Lighting Burners.) Note that
additional time needs to be allowed for the initial lighting as air has to be purged from the pipes.
2. Observe the flame appearance on each burner. (Figure 10) If it is much larger or much smaller
than expected, the injector size and supply pressure require checking. Where a flame is
unsatisfactory, refer to the Troubleshooting Guide (Page 6) to correct the fault. If the
Troubleshooting Guide does not solve the problem, call the Service Centre.
Figure 9
BATTERY HOLDER INSTALLATION INSTRUCTIONS
1. LOCATE A CONVENIENT POSITION TO MOUNT BATTERY
HOLDER KEEPING AWAY FROM HOT SURFACES.
DO NOT ATTACH TO BASE OF COOKTOP.
2. ENSURE MOUNTING SURFACE IS CLEAN.
3. REMOVE PROTECTIVE TAPE FROM REAR OF
HOLDER.
USE OF HOSE ASSEMBLIES:
ENSURE THAT THE HOSE ASSEMBLY IS RESTRAINED
FROM ACCIDENTAL CONTACT WITH THE FLUE OUTLET OF
AN UNDERBENCH OVEN OR ANY OTHER HOT SURFACE
OF AN ADJACENT APPLIANCE.

INSTALLATION