Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
This appliance must be installed by an authorised person
and in compliance with:
1.
AS/NZS 5601.1 Gas Installations Part 1: General
Installations, and AS/NZS 5601.2 Gas Installations
Part 2: LP Gas installations in caravans and boats for
non-propulsive purposes, or the relevant installation
code for gas appliances in your country.
2.
The local gas fitting regulations, municipal building
codes, electrical wiring regulations and any other
relevant statutory regulations.
3.
The particular instructions as given below.
4.
A certificate of compliance MUST be given
to the customer after the application is
successfully installed.
WARNING!
Refer to "Safety information" chapter.
IMPORTANT!
BEFORE INSTALLATION
Before the installation of the appliance, record the
information below from the rating plate. The rating plate is
on the bottom of the appliance casing.
Model ____________________________________________
PNC _____________________________________________
Serial number______________________________________
880
CAUTION!
Cooktops are supplied set up for natural gas (NG).
To use on LPG, the injectors must be changed using
the conversion kit supplied. Refer LP conversion on
page 28-29.
Built-in appliances
Only use the built-in appliances after you assemble the
appliance into correct built-in units and work surfaces that
align to the standards.
Connection cable
•
Use the correct mains cable of type H05BB-F
Tmax 90°C (or higher) 3 x 4mm2 with an all-pole
32A breaker.
•
The earth cord (green/yellow cable) must be 2cm
longer than phase and neutral cable (blue and
brown cables).
gas supply
connection location
490
25
Advertisement
Table of Contents
