Elbow Positioning; Check The Gas Supply - Electrolux GHS605W Instruction And Installation Manual

9.

Elbow positioning

It is possible to reposition the elbow if required by loosening the locking nut and elbow by using two
spanners. Re-tighten the entire assembly after the elbow has been repositioned. When fitting elbow to
appliance, ensure that the sealing washer is fitted.
Checking the gas supply
1 Check the manometer zero point is correct.
2 Connect the manometer to the cooktop pressure point. This is located on the regulator.
3 Turn on the gas supply and electricity and try to ignite the gas.
NOTE! It will take additional time to light the gas for the first time as air needs to be purged from
the pipes.
4 With the appliance operating check the outlet pressure
• when all burners of the appliance are operating at maximum,
• when the smallest burner of the appliance is operating at minimum.
Under these conditions the outlet pressure should not vary from the nominal outlet pressure of
1.00kPa by more than +0.20kPa.
If the regulator appears to not be performing satisfactorily, then check the following points.
1 If the outlet pressure is consistently too low then the inlet pressure may be too low and adjustment
of an upstream regulator may be needed, or an upstream regulator or valve with insufficient flow
capacity may be present in the gas supply line. If this is suspected then it may be necessary to
repeat the checks whilst measuring both the inlet and outlet pressure to determine if the inlet
pressure is in the range 1.13 – 5kPa.
2 Check that the regulator has been fitted to the gas supply line in the correct orientation, the arrow
on the base of the body indicates the direction of gas flow.
Once these checks have been completed, if the regulator still fails to perform in a satisfactory manner
it should be replaced.
LP Conversion – Important
This appliance is fitted with Natural Gas burner injectors.
Please follow the procedure below if a conversion to suit LP gas is required.
The conversion kit contains appropriate LPG injectors and 1 LPG sticker.
1 Remove the hotplate burners to access the hotplate injectors. Replace the factory fitted NG
injectors with the appropriate injectors, as supplied (see Table 2).
2 Unscrew the hex nut from the regulator. The hex nut, brass washer and nylon insert will
disengage as an assembly.
3 Unclip the nylon insert from the nut assembly by rotating the insert ¼ turn, and pulling it free.
4 Turn over the insert, and clip back into position.
5 Refit the hex nut assembly to the regulator ensuring that it is fully screwed down. The regulator is
now set for connection to LP.
6 Turn on the gas supply and at each new connection check for leaks using soapy water: each
hotplate valve should be turned on, one at a time, and the injector hole blanked off for several
seconds.
INSTALLATION