Installation Instructions - Electrolux WHS642SC User And Installation Manual

Solid element cooktops
Table of Contents

Advertisement

installation instructions

warning
WARNING
This must be read! The laws, ordinances, directives and
standards in force in the country of use are to be followed
(safety regulations, proper recycling in accordance with the
regulations, etc.)
important
TIPS & INFORMATION
Installation may only be carried out by a qualified electrician.
The minimum distances to other appliances and units are to
be observed.
Anti-shock protection must be provided by the installation, for
example drawers may only be installed with a protective floor
directly underneath the appliance.
The cut surfaces of the worktop are to be protected against
moisture using a suitable sealant. The sealant seals the
appliance to the work top with no gap. Do not use silicon
sealant between the appliance and the work top. Avoid
installing the appliance next to doors and under windows.
Otherwise hot cookware may be knocked off the rings when
doors and windows are opened.
warning
WARNING
Risk of injury from electrical current.
• The electrical mains terminal is live.
• Make electrical mains terminal free of voltage.
• Follow connection schematic.
• Observe electrical safety rules.
• Ensure anti-shock protection by installing correctly.
• The appliance must be connected to the electrical supply
by a qualified electrician.
• Loose and inappropriate plug and socket connections can
make the terminal overheat.
• Have the clamping connections correctly installed by a
qualified electrician.
• Use strain relief clamp on cable.
warning
WARNING
The surface temperature exceeds 95°C. To avoid a hazard,
underbench access must be restricted.
Electrical Connection
Before connecting, check that the nominal voltage of the
appliance, that is the voltage stated on the rating plate,
corresponds to the available supply voltage. Also check the
power rating of the appliance and ensure that the wire is
suitably sized in accordance with local wiring rules to suit
the appliance power rating. The rating plate is located on
the lower casing of the hob. Means for disconnection must
be incorporated in the fixed wiring in accordance with local
wiring rules. The hob is to be connected to the mains using a
8 INSTALLATION INSTRUCTIONS Cooktops
device that allows the appliance to be disconnected from the
mains at all poles with a contact opening width of at least
3 mm, eg. automatic line protecting cut-out, earth leakage
trips or fuse. The electric hobs are supplied without a cable.
Use a cable H05VV-F 3 x 2.5mm
If this appliance's mains cable is damaged, it must be
replaced by a special cable (type H05VV-F Tmax 90°C; or
higher). The connection must be carried out as shown in the
diagram. The connecting links should be fitted according
to the appropriate connection diagram. The earth lead is
connected to terminal. The earth lead must be longer than
leads carrying electric current. The cable connections must be
made in accordance with regulations and the terminal screws
tightened securely. Finally, the connecting cable is to be
secured with the mains cable cleat and the covering closed
by pressing firmly (lock into place). Before switching on for
the first time, any protective foil or stickers must be removed
from the glass ceramic surface.
warning
WARNING
Once connected to the mains supply check that all cooking
zones are ready for use by briefly switching each on in turn
at the maximum setting.
• A duplicate rating label is supplied with this unit.
For easy identification of this unit after installation, stick it
to a readily available surface adjacent to the cooktop.
Sticking on the seal
• Clean the worktop around the cutout area.
• Stick the single-sided adhesive sealing tape provided
on the underside of the hob around the outside edge
ensuring that it is not stretched. The two ends of the tape
should join in the middle of one side. After trimming the
tape (allow it to overlap by 2-3 mm), press the two ends
together.
T90°C or higher.
2

Advertisement

Table of Contents
loading

This manual is also suitable for:

Whs642wcChs642waChs642saChs942wa

Table of Contents