Installation; Operation On Ng/Sng; Gas Connection; Supply Pipe Sizing - Electrolux GHS605W Instruction And Installation Manual

8.
Figure 7
trivet
seal
benchtop
clamp
Operation on N.G./S.N.G.
Regulator
An appliance regulator is provided. The regulator must be positioned so that the pressure test nipple is
accessible when the appliance is installed. Connect the gas supply to the ½" B.S.P. internal thread
inlet of the regulator. Refer to ʻbench cutoutʼ (Figure 4) for connection point position.
Regulators are supplied pre-adjusted and configured by the component maker for use with Natural
Gas. The appliance installer is not required to make an adjustment to obtain the correct outlet
pressure setting.
An arrow on the base of the regulator indicates the direction of gas flow when the inlet and outlet of
the regulator is orientated correctly. When the regulator has been fitted check for leaks from the
connections with soapy water.

Gas connection

This appliance is supplied for use with Natural Gas. However, it can be converted for use with
LPG. Refer to LP conversion on page 9 & 10.
The total hourly gas consumption for the appliance is shown on the data label. The required supply

Supply pipe sizing

pressure (i.e. at inlet to appliance regulator) for each gas type is shown on the data label, and given in
Table 2. Use this information in conjunction with the length of run, number of elbows, tees and bends,
the available service pressure and the supply requirements of other installed appliances to determine
a suitable pipe size. For assistance in this matter refer to the appropriate section of the Installation
Code AS5601.
An AGA certified class B or D flexible connection may be used to connect the cooktop in accordance
with the AS5601 and in particular section 4.8. Where a hose assembly is used and the cooktop is in
the installed position, the hose assembly shall be suitable for connection to a fixed consumer piping
outlet located at a point 800 – 850mm above the floor and in the region outside the width of the
appliance to a distance of 250mm. The point of connection to consumer piping must be accessible
with appliance installed.
•
hob
•
burner box
• To assemble, attach the 4 clamps to each corner of the
• When placing the cooktop in the cut-out, swing the clamps
• Position the cooktop so it is centred, then swing the
screw clamps under the benchtop and tighten (Figure 7).
• Remove excess seal.
Fit the pull-down clamps supplied to ensure that the cooktop
cannot move after installation. Failure to fix the cooktop to the
bench could result in loosening of the gas connection through
movement of the cooktop and a gas leak may result.
Use the 4 clamps and 4 screws supplied in the parts bag.
burner box via the screws provided.
parallel with the box to avoid interference with the cut-out.

INSTALLATION