Kenwood NX-5300 Service Manual page 59

Item Condition
Panel tuning
mode
18. 1) Adj item:
Battery [BATT]
Warning Adjust:[***]
Level PTT: ON
writing
19. [Panel test mode]
Battery 1) CH-Sig: 1-1
Warning BATT terminal
Level voltage: 6.0V
check while transmitting
Measurement
PC test mode Test-
equip-
ment
1) Adj item: Power
[Battery Warning meter
Level] DVM
Press [Transmit]
button.
1)Test Channel
Channel: 1
Test Signaling
Mode: Analog
Signaling: 1
BATT terminal volt-
age: 6.0V while
transmitting
Unit Ter- Unit Parts
minal
Panel ANT
BATT
termi-
nal
Adjustment
Method
Press the PTT switch or
[Transmit] button on the
PC window. Apply 6.20V
to battery terminal. Con-
firm that one pre-deter-
mined numeric in the
range 1 to 256 appears.
[Panel tuning mode]
Press [ ] key to store
the adjustment value.
[PC test mode]
Press [Apply] button to
store the adjustment val-
ue.
Check The transceiv-
er can trans-
mit with
causing the
LED to blink.
(No.RA015<Rev.002>)1-59
Specifica-
tions
/Remarks