Kenwood NX-5300 Service Manual page 34

Key "FNC" appears on the sub LCD display
Function
[Selector] -
[] Talk Around on/off
[] Analog/Phase1/Phase2/
NXDN
[] -
[] Key/LCD check
[Side1] Function off
[Side2] Function off
[Side3] P25 Modulation Type
(C4FM/LSM) *3
[ ] High power/Low power
• LCD display in panel test mode
Battery type detect
"ALKALI": Alkaline battery pack
"LI ": Li-ion
"LI IS": Li-ion(IS)
" NIMH": Ni-MH
Type
Fx, Kx types are
displayed as "K".
4.2.3 Frequency and Signaling
The transceiver has been adjusted for the frequencies shown in
the following table. When required, readjust them following the
adjustment procedure to obtain the frequencies you want in ac-
tual operation.
(1) Test frequency
CH F2,F3,K2,K3
RX (MHz) TX (MHz)
1 485.05000 485.10000
2 450.05000 450.10000
3 519.95000 519.90000
1-34 (No.RA015<Rev.002>)
Display
-
On: icon appears
Analog: "A"
P25 phase1: "P1"
P25 phase2: "P2"
NXDN: "N"
-
The position of
selector knob, etc.,
appear.
-
-
LSM : icon appears
High: "H"
Medium: "M"
Low: "L"
(Power ON)
Frequency range
"F1": 450~520MHz
"F2": 380~470MHz
*1: Wide 4k is displayed only when the PC test mode is used. However, it aims at production for
factory, or a operation verification of the transceiver. It is not necessary in operation of
the transceiver to adjust.
F5,F6,K5,K6
RX (MHz) TX (MHz)
425.05000 425.10000
380.05000 380.10000
469.95000 469.90000
Key "FNC" appears on the sub LCD display
[ ] Function off
[ ] Compander on/off
[ ] Function off
[AUX For production
(Orange)]
[PTT] Transmit
[0] to [9] Function off
the
and
[#], [ ]
*3: When the mode is selected as P25, this function is enabled.
• LED indicator
Red LED Lights during transmission.
Green LED Lights when there is carrier.
• Sub LCD indicator
"FNC" Appears at function on.
Temperature
Sub LCD display
Main LCD display
(After 2sec.)
An : Analog narrow mode
Aw : Analog wide 5k mode
As : Analog wide 4k mode *1
P1 : P25 Phase1 mode
P2 : P25 Phase2 mode
Nn : NXDN narrow mode
Nv : NXDN very narrow mode
CH F2,F3,K2,K3
RX (MHz)
4 485.00000
5 485.20000
6 485.40000
7~16 -
Function Display
-
On: icon appears
-
-
-
-
Power
Squelch level
(Analog mode only)
F5,F6,K5,K6
TX (MHz) RX (MHz)
485.00000 425.00000
485.20000 425.20000
485.40000 425.40000
-
Signaling
No.
Channel No.
TX (MHz)
425.00000
425.20000
425.40000