Required Test Tapes - Exabyte EXB-8200 Maintenance Manual

1 General Information

1.4 Required Test Tapes

This section describes the tapes that are required to test the EXB-8200 and the
methods to be followed in creating them. Label these tapes appropriately for
easy identification.
Test tape
Read Interchange test tape
Write Interchange test tape
EXABYTE Head Sync Tapes (180223), where applicable.
Test Tape
The test tape is used for all testing with EXPERT test software. It should be
an EXATAPE™ 112m tape.
Read Interchange Test Tape
The tape used for the Read Interchange test should be an EXATAPE 15m
tape. This tape is written by the EXPERT Inter_chg test on a known good
drive.
Write Interchange Test Tape
The tape used for the Write Interchange test should be an EXATAPE 15m
tape. This tape is written by the EXPERT Inter_chg test on the drive being
tested. It is read by a known good drive to verify interchangeability.
EXABYTE Head Sync Tapes
At least two head sync tapes are required to adjust the head sync any time an
SV card or deck is replaced.
4 510003-001