Chapter 2 Mounting; Mount In Free-Stream Application (Flanged Fitting) - Emerson Micro Motion Installation Manual

2 Mounting
Topics covered in this chapter:
•
•
•
•
•
•
•
•
•
2.1 Mount in free-stream application (flanged
fitting)
Prerequisites
Free-stream (flanged) installations are recommended for processes with the following
conditions:
Flow
Viscosity
Temperature
Procedure
See Figure 2-1
stream application.
Important
You must always install the meter horizontally and oriented to allow flow in the gap between the
tines, irrespective of the pipeline orientation (horizontal or vertical). This position helps to prevent
the trapping of bubbles or solids on the meter – allowing the solids to sink and the bubbles to rise.
Installation Manual

Mount in free-stream application (flanged fitting)

Mount in free-stream application (weldolet fitting)
Mount with a T-piece (flanged fitting)
Mount with a flow-through chamber
Mount in an open tank (long-stem meter)
Mount in a closed tank (long-stem meter)
Attach the PFA ring and circlip
Rotate the electronics on the meter (optional)
Rotate the display on the transmitter (optional)
for information on installing the meter (with a flanged fitting) in a free-
0.3 to 0.5 m/s (at the meter)
0.5 to 12,500 cP
-50 °C to 200 °C (–58 °F to 392 °F)
-40 °C to 200 °C (-40 °F to 392 °F) in hazardous
areas
Mounting
11