Ending Therapy; Drying Mode - Somnetics Transcend User Manual

Sleep Apnea Therapy User Manual
Note
In the event of power loss during ramp, the CPAP will resume at the full prescribed pressure as soon as
power is restored.

Ending therapy

To end the delivery of CPAP therapy while the blower is on, press the
If the blower is off while the power is applied, the device is in standby mode. It is recommended that you initiate
drying mode function to clean the Transcend interior after completing each therapy session.

Drying mode

When your therapy session is complete, put the CPAP device in drying mode by holding the
Power
and pressing the
The blower then operates at a relatively low speed without pressure regulation. This allows the air path through
the output hose and the interface to be flushed with fresh air and removes traces of moisture from the CPAP
interior. After 30 minutes, the device automatically enters standby mode.
button.
Power
button to deactivate the blower.
Ramp
Page 35
button down
Using the CPAP