Using The Mobile Power Adaptor - Somnetics Transcend User Manual

Page 32

Using the mobile power adaptor

The Transcend Sleep Apnea Therapy System may be powered with an optional 12VDC mobile power adaptor.
The mobile power adaptor is supplied with two cables: one to connect to your CPAP, and the other to connect to a
mobile power receptacle (e.g. 12VDC automotive/cigarette lighter).
Note
Use only the Somnetics-supplied mobile power adaptor.
1.
Connect both of the cables to the base of the mobile power adaptor.
2. Insert the 12VDC connector into the 12VDC mobile power receptacle (e.g. cigarette lighter).
3. Insert the barrel connector of the mobile power adaptor's output cable to the power jack of the CPAP.
4.
Ensure the CPAP power-up LED flash sequence completes and the LEDs remain off afterwards; this
indicates that power is being supplied to the CPAP and that the CPAP has successfully entered standby
mode.
Note
Make certain that the cables are securely connected to the power adaptor and to the power jack on the
back of the CPAP. It may be necessary to unplug the cables and reconnect to ensure a good connection.
Powering the CPAP
Sleep Apnea Therapy User Manual