Switch Inputs Programming; Switch Inputs Settings - Culligan G1 Series Installation, Operation And Service Instructions

Switch Inputs Programming

RUNNING
JAN-01-12 12:01P
1) GO TO RUNNING
2) GO TO OFFLINE
3) INFORMATION
>4) SETUP
2) LANGUAGE
3) POWERON MODE
4) FLUSH MODES
>5) ACCESSORIES
1) WIRELESS REM
2) MODEM
3) FLOW METERS
>4) SWITCH INPTS

Switch Inputs Settings

Screen Display
PRESSURE SWITCH
NORMALLY OPEN
PS Sw
5
Delay:
SECONDS
SV1 Delay:
10
SECONDS
PRETREAT SWITCH
NORMALLY OPEN
FLOAT SWITCHES
NORMALLY OPEN
Cat. No. 01021713
1. From the default home screen, press
2. Press to scroll to 4) SETUP.
3. Press to select the SETUP menu.
4. Press
cessories menu.
5. Press to select 4)SWITCH INPTS. The screen displays the switch
inputs settings.
Range
Used with the inlet pressure switch. Standard pressure switch is
Normally Open
normally open. Press
Normally Closed
state if necessary.
Sets the pressure switch delay time. This is the number of seconds
0–9,#
the low pressure must exist before activating the switch. Press
each digit
or
The number of seconds elapsed from the inlet solenoid valve (SV-
0–300
1) opening until the motor starts. Press
to change.
Used with the inlet pressure switch. Standard pressure switch is
Normally Open
normally open. Press
Normally Closed
state if necessary.
Used to set whether float switches (level control) are normally
Normally Open
open or closed. There are two float switch contacts; they both must
be normally open or closed. Press
Normally Closed
change the state if necessary.
. The screen displays the main menu.
to select 5)ACCESSORIES. The screen displays the ac-
Changing the Setting
or
and then to change.
or
and then to change the
or and then
and then to change the
or and then to
Setup 39