Table of Contents
Advertisement
6.4
Links
The sensors and actuators created via the "Devices" allocation function can be linked with each
other. A detector can be linked with a second device, e.g. room temperature controller. When
an open window is detected, the room temperature controller changes into "Frost protection"
mode and reduces the set-point temperature to prevent unnecessary loss of energy.
The linking in the list view is made via the linking function of the Web-based user
interface of the System Access Point, which is also integrated in the "Devices"
page.
6.4.1
Linking actuator and sensor
Fig. 15:
Linking actuator and sensor
1. On the working area select the sensor [1] that is to be linked with the actuator.
2. Select the actuator [2] that is to be served by the sensor.
3. Press the tick at the bottom right to take over the entries.
A blue connecting line indicates the link between the two devices. The configuration is now
transmitted automatically to the devices. The transmission can, depending on the number of
affected devices, take a number of seconds. During the transmission a progress bar is
displayed around the devices affected.
Product manual 2CKA001473B9425
Commissioning
│42
Advertisement
Table of Contents
