Table of Contents
Advertisement
Fig. 6:
Inserting the batteries
4. Insert the battery into the device (A).
–
The LED (B) flashes briefly (battery function test).
–
The device is now in programming mode for 10 minutes.
–
The LED (B) now flashes as long as the programming mode is active.
5. The System Access Point now consecutively scans all free@home wireless channels.
Devices that are in programming mode are integrated automatically into the system. The
scanning process ends 10 minutes after the last device has been integrated. Devices are
listed in the "Device list" of the user interface.
6. Use the serial numbers to check whether all installed devices have been found.
If a device has not been found, reset it to the factory settings and start a new scanning
process.
Possible reasons for not finding devices:
The device is not in programming mode.
■
The 10-minute programming time has expired.
■
The device has already been coupled with a different system.
■
Product manual 2CKA001473B9425
B
A
Commissioning
B
A
│35
Advertisement
Table of Contents
