ABB -free@home WBI-S-1-xx-WL Series Product Manual page 36

6.1.1 Resetting the wireless device to the factory settings
A device that has already been programmed must be reset to enable it to be set again into
programming mode.
Fig. 7: Resetting to factory settings
1. Remove the battery (A) from the device and wait 30 seconds.
2. Insert batteries again and simultaneously keep the button (C) pressed for at least 15
seconds, until the LED (B) stops flashing.
– The factory settings are restored and the device can now be programmed again.
Product manual 2CKA001473B9425
C
B
A
Commissioning
C
B
A
│36