NOTE: Take note of additional important information. Not a warning or caution. Regulatory information is delivered with DCI Edge dental equipment as mandated ELECTRICAL HAZARD: Risk of electrical shock by agency requirements and can be found present. Ensure that power is disconnected before in the accompanying Instructions For Use attempting procedure.
SERIES 4 DENTAL CHAIR Installation Instructions SETUP TOOLS NEEDED FOR INSTALLATION • Scissors or utility knife • Allen wrench set • Socket wrench set INCLUDED HARDWARE AND COMPONENTS • Power Switch Cover • Backrest Wire Cover and Fasteners PLACE THE CHAIR IN LOCATION WARNING: To prevent injury, use an assistant to help safely position the chair in the operatory.
SERIES 4 DENTAL CHAIR Installation Instructions CHAIR PREPARATION POWER SWITCH COVER Power Switch Cover: Install the power switch cover into the opening in the truss cover near the power switch by snapping it firmly into place. FOOT SWITCH RETURN TO LAST POSITION PRESET POSITION “0”...
SERIES 4 DENTAL CHAIR Installation Instructions UPHOLSTERY INSTALLATION SEAT UPHOLSTERY Center and place the seat upholstery on the seat plate so that the clips on the bottom of the seat upholstery drop into the slots of the Seat Plate. Engage the clips by pushing the seat upholstery toward the backrest.
SERIES 4 DENTAL CHAIR Installation Instructions OPTIONAL QUICK CONNECT BOX ATTACH BOX TO CHAIR Identify to which side of the chair the box will mount. Drive in screw #1 until the head is 1/8” from the surface. Align the keyhole on the top of the Quick Connection Box to the 1st installed screw and slide the box until the screw is engaged in the slot.
SERIES 4 DENTAL CHAIR Insallation Instructions ADJUSTING THE CHAIR POSITION SOFT LIMITS PROGRAMMING SOFT LIIMITS Soft Limits are the software controlled position limits for the hydraulic chair movements. These can be programmed using the foot switch or any touchpad that controls chair movement. Soft limits are factory set and should only be adjusted by a technician.
SERIES 4 DENTAL CHAIR Installation Instructions DIAGNOSTIC STATUS CODES SAFETY SWITCHES Status Codes are displayed on a two 7-segment display on Display Status If this status is incorrect the chair control circuit board. These are visible through the 1. Check the safety cover and ensure that it is free clear window of the protective cover.
Page 13
DIAGNOSTIC TOOL SMART PHONE APPLICATION You can connect to this chair using an Android or iOS based smart phone and the DCI Edge Diagnostic Tool App. This application provides the following features: 1. View status information of the chair in its current state along with troubleshooting tips for error conditions.
Page 14
www.dcionline.com DCI International, LLC PN 40078, Rev. A, 2019-03-08 800-624-2793 305 N. Springbrook Road Newberg, OR 97132, USA...