Setup - DCI Edge 4 series Installation Instructions Manual

SERIES 4 DENTAL CHAIR
Installation Instructions

SETUP

TOOLS NEEDED FOR INSTALLATION
• Scissors or utility knife
• Allen wrench set
• Socket wrench set
INCLUDED HARDWARE AND COMPONENTS
• Power Switch Cover
PLACE THE CHAIR IN LOCATION
1
Remove the shipping straps and open the crate.
Remove the 3/8" bolts holding the chair to the
2
wood pallet.
Carefully remove the chair from the pallet and position it in the proper location for installation. Refer to dimensional
3
information on the next page for guidance in positioning the chair.
Check that the chair rests flat and level on the floor and that it does not rock due to uneven areas on the floor.
4
Use shims to eliminate gaps if the surface is uneven.
4
• Backrest Wire Cover and Fasteners
WARNING: To prevent injury, use an
assistant to help safely position the chair in
the operatory.