Upholstery Installation - DCI Edge 4 series Installation Instructions Manual

UPHOLSTERY INSTALLATION

SEAT UPHOLSTERY
Center and place the seat upholstery on the seat
1
plate so that the clips on the bottom of the seat
upholstery drop into the slots of the Seat Plate.
Engage the clips by pushing the seat upholstery
2
toward the backrest.
Once the clips are engaged, turn the two rotating
3
catches 90 degrees to lock the seat in position.
WARNING: Failure to properly assemble
the seat upholstery to the chair could result
in injury or damage to the equipment.
BACKREST UPHOLSTERY
Attach the backrest upholstery by aligning the
1
lower keyhole features in the plastic substrate to
the flat head elevator bolts on the metal back.
Push down and slide the backest upholstery
2
toward the seat until the upper keyhole features
catch on the upper elevator bolts.
Ensure that the upper elevator bolts engage in
3
the upper keyhole slots of the backrest uphol-
stery substrate and continue to push the backrest
toward the seat until it is fully engaged on the metal
back.
HEADREST UPHOLSTERY
Remove the 6-32 screw from the back of the headrest upholstery
1
and set aside.
Align the keyholes of the headrest upholstery to the flat head bolts
2
on the headrest assembly.
Push down and slide the headrest upholstery toward the bottom
3
tip of the casting to engage the bolts in the keyhole slots.
Complete the assembly by adding the 6-32 screw to the back of
4
the headrest as shown (right).
2
1
SERIES 4 DENTAL CHAIR
Installation Instructions
7