Optional Quick Connect Box - DCI Edge 4 series Installation Instructions Manual

SERIES 4 DENTAL CHAIR
Installation Instructions

OPTIONAL QUICK CONNECT BOX

ATTACH BOX TO CHAIR
Identify to which side of the chair the box will
1
mount.
Drive in screw #1 until the head is 1/8" from the
2
surface.
Align the keyhole on the top of the Quick
3
Connection Box to the 1st installed screw and
slide the box until the screw is engaged in the slot.
Then, add screw #2 as shown.
ROUTE LINES
Route tubings out the hole on the side of the
1
Quick Connection Box which is closest to the
chair casting.
Route the tubings from the back side of the
2
Quick Connection Box down through the
opening under the seat casting. Remove the safety
cover and route the tubings through the tubing
managers on the back side of the truss casting.
Remove the top cover of the Junction Box in
3
front of the chair and route air and water lines
through the opening at the front of the chair into the
Junction Box. Make air and water connections to the
incoming air and water lines after the regulator.
8
1
2