Connect Triggering Device; Prime Before Using Equipment - Graco InvisiPac GS35 Plug-Free Instruction Manual

Installation
Connect Triggering Triggering Device
Connect Connect Triggering
Identify if your model uses a 24 VDC or 110 VAC
solenoid valve. Connect solenoid valve to 24 VDC
or 110 VAC signal.
Improper electrical connection can result in electric
shock. All electrical wiring must be done by a
qualified electrician and comply with all local codes
and regulations.
1. Loosen the mounting screw and disconnect the
electrical connector (N) from the solenoid valve
(J). Set the gasket and screw aside.
Figure 6 Solenoid Valve Electrical Connector
10
Device
Device
N
P
J
2. Insert a small screwdriver where the mounting
screw was removed and gently press the
electrical connector (P) out of the electrical
connector housing (N).
3. Thread a three-conductor cable through the strain
relief. Connect the positive and negative wires to
terminals 1 and 2 on the electrical connector (P).
Connect the ground wire to the ground terminal.
Note
It does not matter which terminal
the positive and negative wires are
connected to.
1
Solenoid Valve Connector
Figure 7
4. Reassemble the electrical connector (P) and
housing (N). Retighten strain relief.
5. Place the gasket on the housing and connect the
electrical connector into the solenoid valve (J)
with the mounting screw. See
Prime Prime Before Prime Before Using Before Using Equipment Using
The equipment was tested with oil, which is left in the
fluid passages to protect parts. Prime the equipment
with hot melt until all of the oil is pushed out before
using the equipment. See
2
GND
Fig. 6.
Equipment Equipment
Flush, page 11.
3A2805M