Nexcom NDIS M537 User Manual page 56

Chapter 4: BIOS Setup
Hardware Monitor
This section is used to monitor hardware status such as temperature, fan
speed and voltages.
Aptio Setup Utility - Copyright (C) 2018 American Megatrends, Inc.
Advanced
PC Health Status
Smart Fan Function [Disabled]
CPU temperature : +62 ºc
CPU FAN Speed : 4115 RPM
System Fan Mode [Enable]
VCORE : +0.872 V
VCC5 : +5.100 V
VCC3 : +3.312 V
Version 2.18.1263. Copyright (C) 2018 American Megatrends, Inc.
Smart Fan Function
Enables or disables the smart fan function.
System Fan Mode
Configures the operating mode of the system fan.
Copyright © 2018 NEXCOM International Co., Ltd. All Rights Reserved.
S5 RTC Wake Settings
This section is used to configure system to wake from S5 using RTC alarm.
Enable or Disable Smart Fan
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
Wake System from S5
Enables or disables system wake on alarm event. When FixedTime is selected,
system will wake on the hr::min::sec specified. When DynamicTime is
selected, system will wake on the current time + Increase minute(s).
42
Aptio Setup Utility - Copyright (C) 2018 American Megatrends, Inc.
Main
Advanced Chipset PCIPnP
Wake system from S5 [Disabled]
Version 2.18.1263. Copyright (C) 2018 American Megatrends, Inc.
Exit
Security
Enable or disable System wake
on alarm event. Select
FixedTime, system will wake on
the hr::min::sec specified.
Select DynamicTime , System
will wake on the current time
+ Increase minute(s)
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
NDiS M537 User Manual