Nexcom NDIS M537 User Manual page 40

Chapter 3: System Setup
3. Insert the module into the socket at an approximately 30 degree angle.
Apply firm even pressure to each end of the module until it slips down
into the socket. The contact fingers on the edge of the module will almost
completely disappear inside the socket.
The ejector tabs at the ends of the socket will automatically snap into
the locked position to hold the module in place.
Copyright © 2018 NEXCOM International Co., Ltd. All Rights Reserved.
4. At the bottom of the system, loosen the screws on the bottom cover, then
remove the cover from the chassis to install another memory module.
26
NDiS M537 User Manual