Connecting Optional Device(S); 510 And V X 570 Optional Device Connections - VeriFone Omni 5 series Installation Manual

T S
ERMINAL ETUP

Connecting Optional Device(s)

Connecting
Optional
Device(s)
CAUTION
NOTE
x x
V 510 and V
Optional Device
Connections
24
O 5 V X 5
MNI XXX AND
x x
The V 5xx/V 610 series of terminals supports some peripheral devices designed
for use with electronic point-of-sale terminals.
Before connecting any peripheral device, remove the power cord and/or battery
(see Installing the V
green indicator LED is not lit. Reconnect the power cord and/or battery only after
you are finished connecting the peripheral device(s). For complete information
about peripheral installation and use, refer to the user documentation supplied
with those devices.
Different terminals support different devices, so for more information about
optional devices, please contact your VeriFone distributor.
RS-232-type devices do not work on the PINpad port. PINpad-type devices do not
work on the RS-232 port. If an optional peripheral device does not function
correctly, check the port connection.
x
570 For the V 510 and V
two optional devices.
Connecting the PINpad or Smart Card Reader to the V
Use the following procedure to connect a PINpad or smart card reader.
1
Insert the RJ45-type connector on the end of the PINpad or smart card reader
into the port on the back of the peripheral device.
To install a PINpad 101, PINpad 201, or PINpad 1000, position and insert the
grommet to secure the cable connection.
If a cable is not already connected to the smart card reader or PINpad, insert
the small modular plug on one end of the interface cable into the optional
device's modular jack.
/V X 610 I G
XX NSTALLATION UIDE
x
610 Smart Battery) from the terminal and ensure that the
x
570, use the two ports on the back panel to connect up to
x x
or V
510 570