Removal; Charging; Battery Life - VeriFone Omni 5 series Installation Manual

T S
ERMINAL ETUP
x
Installing the V 610 Smart Battery

Removal

Charging

NOTE

Battery Life

WARNING
34
O 5 V X 5
MNI XXX AND
To remove the V
and pull the smart battery from its slot.
Figure 30 Detaching the Smart Battery from the V
After unpacking your V
pack to the unit for 6 hours. Failure to do so may result in inaccurate battery status
messaging.
VeriFone also recommends that the smart battery receive a periodic full
discharge. To ensure a full discharge, use the unit until the battery is fully drained.
The smart battery has a safety circuit to protect the Li-ion cells from overcharging
and over-discharging. If the battery is over-discharged, the safety circuit shuts
down the battery. The battery must then be recharged to restore operation.
x
The V 610 terminal automatically shuts off when the smart battery reaches the
critically low charge state. If this occurs, the smart battery must be recharged for a
minimum of 1/2 hour before it can power the terminal. It may take several
recharge attempts to reset the safety circuit when charging a smart battery that
has been discharged below this critical state.
x
The V 610 smart battery can be charged and discharged hundreds of times, but
will eventually wear out. When operating times are noticeably shorter than usual,
it is time to buy a new battery (see
information).
Do not dispose of batteries in a fire. Li-ion batteries must be recycled
or disposed of properly. Do not dispose of Li-ion batteries in municipal
waste sites.
/V X 610 I G
XX NSTALLATION UIDE
x
610 smart battery, press the locking tab at the top of the battery
x
610 terminal, install the battery and connect the power
Accessories and Documentation
x
610 Terminal
for ordering