Orientation; Replacing The Antenna - VeriFone Omni 5 series Installation Manual

4
Screw the barrel nut finger tight to retain the antenna.
Figure 43

Orientation

To establish good wireless communication (uplink), vertically align the antenna
with respect to ground and
horizontally, position the antenna approximately at a 90° angle to the unit (that is,
pointing up from the ground). This should point the antenna directly at the sky.
If the unit is on a flat surface (for example, a table top) position the antenna so that
it points directly at the sky.
NOTE
If an application (for example, SoftPay) is installed in your V
strength indicator may appear on the display.
Replacing the
If your V
Antenna
have to replace the antenna. Use the following procedure to replace the antenna:
1
Remove the existing antenna from the V
a
b
2
Align the connector on the end of the new antenna with the connector on the
end of the terminal.
3
Push gently on the center of the base of the antenna until it slides into
position.
4
Screw the barrel nut finger tight to retain the antenna.
Tighten Antenna Barrel Nut
sky.
x
610 terminal has difficulties completing wireless transactions, you may
Unscrew the barrel nut to loosen the antenna.
Pull gently on the center of the base of the antenna until it slides out of
position.
Connecting the V
For example, if standing and holding the terminal
x
610 terminal:
O 5 V 5
X
MNI XXX AND
T
ERMINAL
x
610 External Antenna
x
610 unit, a signal
/V 610 I G
X
XX NSTALLATION UIDE
S
ETUP
41