Table of Contents
Advertisement
S
ETUP
Connecting Unit to a Controlling Device
Connecting Unit
to a Controlling
Device
To connect to a
controlling device
NOTE
RS-232
CAUTION
NOTE
14
QX700 I
NSTALLATION
The device's rear panel has a modular, RS-232 interface port for power and
communication connection to the controlling device.
This section discusses various connections between the contactless unit and
controlling devices.
1
Connect the modular plug on the cable to the modular jack on the rear of the
contactless device.
2
Connect the other end of the cable to the connector (device dependent) of the
controlling device. See
The cable used is controlling device-dependent. Various connections include:
vending machines, electronic payment terminals, PCs, and other VeriFone
unattended terminals. Contact your local VeriFone representative or distributor to
see which connections are suitable for your needs. See
Documentation
for cable ordering information.
1
ABC
DEF
2
X
JKL
MNO
5
<
PQRS
TUV
8
9
#
Figure 6
Various QX700 Cabling Connections
Using an incorrectly rated power supply can damage the unit or cause it to not
work properly.
For cable removal, use the same steps described above in reverse. If
exchanging cables, use a VeriFone-approved cable.
G
UIDE
Figure 6
for different cabling situations.
Accessories and
Advertisement
Table of Contents
