Software Components - Siemens SINAUT ST7 System Manual

● Connecting cable for connecting TIM 33/43 / MD3 to TAE6 / LTOP
6NH7700-3BR60
● Connecting cable for connecting TIM 34/44 / MD4 to S
6NH7700-4AR60
When ordering the respective devices (as spare parts), the corresponding discontinued
connecting cables are included in the delivery.
1.2.2

Software components

Configuration software
Alternatively, you can use it for configuration and diagnostics as well as for SINAUT
communication:
● STEP 7 V5 - SINAUT Engineering Software
SINAUT Engineering Software running under STEP 7 V5 contains:
– SINAUT ST7 configuration and diagnostic software for the programming device
– TD7onTIM: TD7 program blocks on the TIM (no memory required on the CPU)
– TD7onCPU: The TD7 program block library for the CPU (alternative to TD7onTIM)
SINAUT Engineering Software is documented in Volume 2 of this system manual.
● TIA Portal - STEP 7 Professional
Use STEP 7 Professional in the TIA Portal for configuration and diagnostics.
The functions for ST7 communication can also be used:
– TD7onTIM: Configuring functions in STEP 7 Professional
– TD7onCPU: The TD7 program block library for the CPU (alternative to TD7onTIM)
Configuration is documented in Volume 3 of this system manual.
You can find the required software versions in the section Preface (Page 3).
Control center software
● SINAUT ST7cc
Expansion package for WinCC consisting of:
– ST 7 Server, the interface between ST7 and WinCC
– ST7cc Config, the configuration tool for ST7cc.
● SINAUT ST7sc
SCADA Connect software, consisting of:
– OPC server, the interface between ST7 and an OPC client.
– ST7sc Config, the configuration tool for ST7sc.
For the manuals see /5/ (Page 130) and /6/ (Page 130).
SINAUT ST7 - Volume 1
System Manual, 11/2018, C79000-G8976-C178-12
The SINAUT ST7 system
1.2 Components in a SINAUT ST7 system
interface
0
21