3. CAP HEATER AND PLAIN HEAT PLATEN EXCHANGE
1. Unplug the power socket
①
screw bolt
2. Leave the left hand and the cap platen is now lying on the cap under plate
Release screw nut
3. Fix two screws
⑥
nut
to fix the flat under plate
4. Place flat heat platen
②
bar grip
, and adjust the heat platen mounts and adjustment bolt with right hand, then
tighten the screw
5. Use left hand press down the handle bar grip
aligned with flat under plate⑧. Fasten the screw bolt
power socket
The exchange process is done.
④
, press down the handle bar grip
with right hand.
⑥
to take out the cap press parts.
⑨
in the flat under plate
⑧
⑩
above the flat under plate
①
.
④
.
⑧
and mount it to the support arm
.
⑧
, use left hand to press down the handle
②
again to make sure the flat heat platen
①
Page 7
②
with left hand and release
⑤
.
⑥
and screw nut
tightly and plug the
V0414
⑦
, fasten screw
⑩
is
Need help?
Do you have a question about the Initium iCAP 2 and is the answer not in the manual?