Order Code Of Temposonics ® R-Series V Rh - MTS Systems R Series V Operation Manual

R-Series V EtherNet/IP™
Temposonics
®
Operation Manual
3.2 Order code of Temposonics
1 2 3 4 5
R H 5
a b c
a Sensor model
R H 5 Rod
b Design
B Base unit (only for replacement)
J Threaded flange M22×1.5-6g (rod Ø 12.7 mm, 800 bar)
M Threaded flange M18×1.5-6g (standard)
S Threaded flange ¾"×16UNF - 3A (standard)
T Threaded flange ¾"×16UNF - 3A (with raised-face)
c Mechanical options
A Standard
B Bushing on rod end (only for flange option »M«, »S« & »T«)
M Thread M4 at rod end (only for flange option »M«, »S« & »T«)
V Fluorelastomer seals for the electronics housing
d Stroke length
X X X X M 0025...7620 mm
Standard stroke length (mm)*
25 ... 500 mm
500 ... 750 mm
750...1000 mm
1000...2500 mm
2500...5000 mm
5000...7620 mm
.
U 001.0...300.0 in.
X X X X
Standard stroke length (in.)*
1 ... 20 in.
20 ... 30 in.
30 ... 40 in.
40...100 in.
100...200 in.
200...300 in.
e Number of magnets
X 01...20 Position(s) (1...20 magnet(s))
X
*/ Non standard stroke lengths are available; must be encoded in 5 mm / 0.1 in. increments
R-Series V RH
®
6 7 8 9 10 11 12
d e
Ordering steps
5 mm
10 mm
25 mm
50 mm
100 mm
250 mm
Ordering steps
0.2 in.
0.4 in.
1.0 in.
2.0 in.
4.0 in.
10.0 in.
13 14 15 16 17
D 5 1 U
f g
f Connection type
6 2 × M12 female connectors (5 pin),
D 5
1 × M8 male connector (4 pin)
D 5 8 2 × M12 female connectors (5 pin),
1 × M12 male connector (4 pin)
g System
Standard
1
h Output
U 2 0 1 EtherNet/IP™, position and velocity
(1...20 positions)
1 EtherNet/IP™, position and velocity,
U 2 1
internal linearization (1...20 positions)
NOTICE
• For applications using more than 1 magnet, order the
additionalmagnets separately.
• The number of magnets is limited by the stroke length.
The minimum allowed distance between magnets (i.e. front face
of one to the front face of the next one) is 75 mm (3 in.).
• Use magnets of the same type for multi-position measurement,
e.g. 2 × U-magnets (part no. 251 416-2).
I 6 I
18 19 20
2
h