Technical Data; Technical Data Temposonics ® R-Series V Rp - MTS Systems R Series V Operation Manual

R-Series V EtherNet/IP™
Temposonics
®
Operation Manual

10. Technical data

9.1 Technical data Temposonics
Output
Interface
Data protocol
Data transmission rate
Measured value
Measurement parameters
Resolution: Position
Cycle time
Linearity deviation
5
Repeatability
Hysteresis
Operating conditions
Operating temperature
Humidity
Ingress protection
Shock test
Vibration test
EMC test
Magnet movement velocity
Design / Material
Sensor electronics housing
Sensor profile
Stroke length
Mechanical mounting
Mounting position
Mounting instruction
Electrical connection
Connection type
Operating voltage
Power consumption
Dielectric strength
Polarity protection
Overvoltage protection
5/ With position magnet # 252 182
6/ Power supply must be able to provide current of 1 A for power up process
R-Series V RP
®
EtherNet/IP™
Encoder CIP device profile with CIP Sync and DLR capabilities
100 MBit/s (maximum)
Position, velocity / option: Simultaneous multi-position and multi-velocity measurements up to 20 magnets
1...500 µm (selectable)
Stroke length up to 2000 mm
Cycle time 1.0 ms
Stroke length up to 500 mm
Linearity deviation ≤ ±50 µm
< ±0.001 % F.S. (minimum ±2.5 μm) typical
< 4 µm, typical 2 µm
−40...+85 °C (−40...+185 °F)
90 % relative humidity, no condensation
IP65 (connectors correctly fitted)
150 g / 11 ms, IEC standard 60068-2-27
30 g / 10...2000 Hz, IEC standard 60068-2-6 (excluding resonant frequencies)
Electromagnetic emission according to EN 61000-6-3
Electromagnetic immunity according to EN 61000-6-2
The sensor meets the requirements of the EC directives and is marked with
Magnet slider: Max. 10 m/s; U-magnet: Any; block magnet: Any
Aluminum (painted), zinc die cast
Aluminum
25...6350 mm (1...250 in.)
Any
Please consult the technical drawings on
2 × M12 female connectors (5 pin), 1 × M8 male connector (4 pin),
2 × M12 female connectors (5 pin), 1 × M12 male connector (4 pin)
12...30 VDC ±20 % (9.6...36 VDC)
Less than 4 W typical
500 VDC (DC ground to machine ground)
Up to −36 VDC
Up to 36 VDC
up to 4800 mm up to 7620 mm
2.0 ms 3.0 ms
greater than 500 mm
< 0.01 % F.S.
page 9
6
I 34 I