To Set Up Auxiliary Output; Date & Time; To Set Time And Date Manually - LeCroy WaveRunner 6000A Series Getting Started

W R
A V E U N N E R
Square Wave
Trigger Out -- can be used to trigger another
scope
DC level -- a reference level
Trigger Enabled -- can be used as a gating
function to trigger another instrument when the
scope is ready
Pass/Fail -- allows you to set a pulse duration
from 1 ms to 500 ms; generates a pulse when
pass/fail testing is active and conditions are met.
Aux Output Off -- turns off the auxiliary output
signal

To Set Up Auxiliary Output

1. In the menu bar, touch Utilities, then Utilities Setup... in the drop-down menu.
2. Touch the Aux Output tab.
3. If you simply want a 1 kHz, 1 V square wave, touch the button so labeled.
4. If you want a specialized output, touch one of the buttons under Use Auxiliary Output
For.
5. Touch inside the Amplitude data entry field and enter a value, using the pop-up numeric
keypad. If you want a TTL level signal, touch the TTL Level checkbox. The Amplitude
field will accordingly become unavailable.
6. If you selected Square Wave, touch inside the Frequency data entry field and enter a
value, using the pop-up keypad. You can set a value from 5.0 Hz to 5 MHz.
7. If you selected Pass/Fail, touch inside the Pulse Duration field and enter a value from 1
ms to 500 ms, using the pop-up numeric keypad.
DATE & TIME
The instrument gives you the choice of manually setting the time and date or getting it from the
Internet. If you elect to get the time and date from the Internet, you need to have the scope
connected to the Internet through the LAN connector on the rear panel. You can also set time
zones and daylight savings time.

To Set Time and Date Manually

1. In the menu bar touch Utilities, then Utilities Setup... in the drop-down menu.
68
6 0 0 0 A S
E R I E S
ISSUED: July 2005 WR6A-GS-E Rev B