Shoulder Strap (Option) - Toshiba B-FP3D SERIES Owner's Manual

How to attach the accessories
CAUTION!
1. Care should be taken not to drop the printer when securing it to your waist or slinging it over your shoulder.
2. For fixing the printer to your belt, the belt width should be 40 mm or less Use of the other belts may cause the
printer to fall off .
ATTENTION!
1. Prenez garde à ne pas faire tomber l'imprimante lorsque vous la mettez à la ceinture ou à l'épaule.
2. La largeur de votre ceinture ne doit pas dépasser 40 mm pour assurer une bonne fixation de la pince de
ceinture, faute de quoi l'imprimante risque de se détacher et de tomber.
 Belt Clip
When you want to use the printer on belt, first secure
the supplied Belt Clip to the rear of the printer.
1. Secure the Belt Clip to the printer back with the
two screws.
NOTE:
Only use the supplied screw to secure the Belt Clip.
Use of other screw may damage the inside of the
printer.
2. Fasten the Belt Clip to your belt.
 Shoulder Strap (Option)
Use the following procedure to fasten an optional
shoulder strap (B-EP900-SS-QM-R) to the printer.
1. Pass either end of the Shoulder Strap through the
strap slot on the front of the printer.
2. Pass the end of the Shoulder Strap through the
buckle. Slide the buckle to adjust the length of the
Shoulder Strap.
3. Repeat for the other end of the Shoulder Strap.
Strap Slot
31
Belt Clip
M-3x8 Screws
Belt Clip
Belt
Shoulder Strap
Buckle