Replacing The Solenoid (Standard On The B-Sx8T, Option For The B-Sx6T) - Toshiba B-SX6T SERIES Maintenance Manual

3.MAIN UNIT REPLACEMENT
2.6 Replacing the Solenoid
(Standard on the B-SX8T, Option for the B-SX6T)
NOTE: The following procedure can be done without removing the Left Side Cover.
1. Remove the two SMW-4x8 screws, detach the connectors, and remove the Solenoid Unit (R).
2. Remove the two SMW-4x8 screws, disconnect the cables from CN1, CN2, and CN3 on the RSV2 PC
Board and detach the Solenoid Unit (L).
CN2 (Solenoid R)
RSV2 PC Board
CN1
(Solenoid L)
3. Remove the two SMW-4x8 screws from each of the Solenoid Units (L) and (R) to detach the Solenoid.
4. Replace the Solenoid and attach it to the Solenoid Attachment Plate. Be careful of the differences in
length of the Solenoid Cables when installing the Solenoid.
5. Assemble the Solenoid Unit so that the Head Up Link engages the spring pin.
NOTE: Be sure to remove any dust that appears during removal or installation because it may affect the print
quality .

2.6 Replacing the Solenoid (Standard on the B-SX8T, Option for the B-SX6T)

Solenoid
CN3
Solenoid Unit (L)
Connector
Spring Pin
Head Up Link
2- 9
SMW-4x8 Screw
Solenoid
EO18-33017
Solenoid Unit (R)