Table of Contents
Advertisement
9.5 Convert the Archer2 as a USB port
The Archer
2
has a slot for a micro SD card located in the battery compartment. To insert or remove
a card follow these steps (As per the Archer
1) Power off the handheld by holding the power button until the Power Button menu appears
and selecting Power Off. CAUTION: Power-off the Archer
remove the battery without powering-off the handheld, you may damage the handheld
and/or lose data.
2) Loosen the screws to the battery compartment, and remove the door. The hand strap
remains attached. CAUTION: The Archer
battery door is not installed properly.
3) Remove the battery pack.
4) An image on the battery compartment label shows the correct location and orientation for
the SD card (slot on the right). Push the card into the slot to insert it. To remove the SD card,
pull it out.
5) Replace the battery pack, and attach the battery door.
6) Power up the handheld.
Once, the SD card is installed. In the main screen of the Archer
1. In the main screen of the Archer
2. Go in the ''connections'' folder and then select the ''USB to PC option''.
3. Select ''SD Card - Use as external drive (Mass Storage)''
4. The Archer
2
can now be accessed from the Windows File Explorer.
Instrumentation GDD Inc.
2
User Guide):
2
is not sealed against water and dust when the
2
, go in the Settings menu
2018-09-18
2
before removing the battery. If you
2
, go in the Settings menu.
Page 56
Advertisement
Table of Contents
