Table of Contents
Advertisement
3 SCIP tester components
The SCIP tester components are described in this section.
A - RS-232 connector - 9 pin serial communication port
This connector is used to connect the RS-232 cable between the Archer
SCIP tester.
B - CABLE/WIRELESS switch
This switch is used to select CABLE (RS-232) or WIRELESS (Bluetooth) communications with
the PDA. The red light indicates the WIRELESS position.
C - ON/OFF switch
This switch is used to turn the SCIP tester ON. The red light indicates that the SCIP tester is
ON.
D - CHARGER connector
This connector is used to charge the SCIP tester's battery with the AC charger, and to supply
power to the SCIP tester when the battery is discharged.
E - TX terminals
Transmitting connectors.
F - RX terminals
Receiving connectors.
Instrumentation GDD Inc.
B
A
C
F
E
2018-09-18
D
2
Field PDA and the
Page 5
Advertisement
Table of Contents
