Table of Contents
Advertisement
For a core sample, select Diameter and enter the diameter of the cross section in mm. If
you measure a half core sample, select Half Sample.
For any other type of sample, enter the cross-sectional area in mm
12. In the 'Windows' window, select the maximum number of stacks, the signal time and the
mode (windows time definition). See Section 8.1 for more details.
The time to get one reading increases with the number of stacks and the signal timing. It
could take up to three (3) hours to get one reading with 50 stacks at a timing of 128 seconds.
13. In the 'TX' window, select if you want to use a constant voltage or a constant current. You
can use a voltage of 3, 6, 9 or 12 volts or a current of 0.5, 5, 50 or 500 µAmps.
Instrumentation GDD Inc.
2018-09-18
2
.
Page 13
Advertisement
Table of Contents
