Table of Contents
Advertisement
1
Introduction
The SCIP (Sample Core I.P.) tester is an efficient, compact, lightweight and low consumption unit
designed for resistivity measurements.
The SCIP tester uses a field handheld computer to process data acquisition. The operating system
is Windows Embedded Handheld 6.5 Professional.
Characteristics:
Related to the GDD Rx 8-32: The SCIP acts as a 1 dipole receiver relating DDH Cores to the
resistivity and IP surveys.
Programmable windows: The SCIP offers twenty fully programmable windows for higher
flexibility in defining the IP decay curve.
Available Modes: Arithmetic, logarithmic, semi-logarithmic, Cole-Cole and user defined.
IP display: Chargeability values, Resistivity and IP decay curves are displayed in real time on
a PDA.
Internal memory: Over 100 000 readings can be stored in the PDA's internal memory. Each
reading includes the full set of measurement parameters. Data are stored on flash type
memory and cannot be lost even if the PDAs battery is totally discharged or absent.
Transmitting mode: Can be used as a low voltage transmitter of 3, 6, 9 or 12V or 0.5, 5, 50 or
500uA.
Instrumentation GDD Inc.
2018-09-18
Page 3
Advertisement
Table of Contents
