Table Of Contents - Hayward HRSN2 series Installation, Operation And Maintenance Instructions

TABLE OF CONTENTS

Important Safety Instructions . . . . . . . . . . . . . . . . . . . . . 2
Table of Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
LCS Supplement to HRS Series Actuators . . . . . . . . . . 4
Conventions Used in this Manual . . . . . . . . . . . . . . . . . . 5
Theory of Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
HRCK, HRCP On/Off Control . . . . . . . . . . . . . . . . . . 6
HRCK, HRCP Proportional Control . . . . . . . . . . . . . . 7
HRCL, HRCD On/Off Control . . . . . . . . . . . . . . . . . . 8
HRCL, HRCD Proportional Control . . . . . . . . . . . . . . 9
CK Series LCS Operation . . . . . . . . . . . . . . . . . . . . . . . 10
CP Series LCS Operation . . . . . . . . . . . . . . . . . . . . . . . 11
CL Series LCS Operation . . . . . . . . . . . . . . . . . . . . . . . 12
CD Series LCS Operation . . . . . . . . . . . . . . . . . . . . . . . 13
LCS Calibration and Commissioning . . . . . . . . . . . . . . 14
HRCK On/Off Control . . . . . . . . . . . . . . . . . . . . . . . 14
HRCK Proportional Control . . . . . . . . . . . . . . . . . . . 16
HRCP On/Off Control . . . . . . . . . . . . . . . . . . . . . . . 18
HRCP Proportional Control . . . . . . . . . . . . . . . . . . . 20
HRCL On/Off Control . . . . . . . . . . . . . . . . . . . . . . . 22
HRCL Proportional Control . . . . . . . . . . . . . . . . . . . 24
HRCD On/Off Control . . . . . . . . . . . . . . . . . . . . . . . 26
HRCD Proportional Control . . . . . . . . . . . . . . . . . . . 28
Notes . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 31
Notice:
HRCK, HRCP, HRCL & HRCD Series actuators are fully assembled, calibrated and tested prior to
leaving our factory. In most cases, after you have mounted the actuator to your device, you should be able to
operate the actuator from fully CLOSED (CW) to fully OPEN (CCW) and back again, and find that no adjustments
are needed. The assembly can be put into service immediately.
If, however, it should be necessary to make adjustments to the end-of-travel positions to overcome any device
related issues (i.e. valve shaft incorrectly timed to the drive stem), the procedures outlined in the Installation,
Operation and Maintenance Instructions (IOM) for each unit should be followed to put the assembly into
service. Note that there is a maximum adjustment range of +/- 3° at each end of travel.
For any 3 Phase products (i.e. HRCK4AR8), refer to the IOM for the respective 3 Phase unit.
CAUTION -
These instructions are specific to low voltage and single phase products only.
Back to TOC
Hayward Flow Control
1-888-HAY-INDL (1-888-429-4635)
Mechanical Data . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 32
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
www.haywardflowcontrol.com
HR2~6 LVHV LCS Series
HRCK2A~2S Exploded View . . . . . . . . . . . . . . . . . . 32
HRCK2A~2S Dimensional Data
HRCK, HRCP 3A~4F Exploded View . . . . . . . . . . . 34
HRCK, HRCP 3A~4F Dimensional Data
HRCK, HRCP 5A~6A Exploded View . . . . . . . . . . . 36
HRCK, HRCP 5A~6A Dimensional Data
HRCL, HRCD 3A~4F Exploded View . . . . . . . . . . . 38
HRCL, HRCD 3A~4F Dimensional Data
HRCL, HRCD 5A~6A Exploded View . . . . . . . . . . . 40
HRCL, HRCD 5A~6A Dimensional Data
. . . . . . . . . . . . . . 33
. . . . . . . . 35
. . . . . . . . 37
. . . . . . . . 39
. . . . . . . . 41
HRSLCSSPLMNTIOM Rev A
Page 3 of 42