Description Of Options - Electrolux EWF1284EDW Service Manual

9.2 Description of options


Rinse hold
 During the cycle the intermediate rinses and spins are performed.
 Stops the appliance with water in the tub before the final spin cycle.
 To drain the water, simply press the START/PAUSE button to run the drain and spin cycles.

Pre-wash
 Adds a pre-wash phase at the start of the cycle with water heating to 30°C (or cold, if selected).
 In COTTON and SYNTHETICS cycles, performs a short spin before passing on to the washing phase.
 This option cannot be selected for WOOL and HAND WASH cycles.

EXTRA-rinse
 Add two rinses to the cycles where featured.
 Eliminates the spin at the end of washing.
ENABLING/DISABLING EXTRA RINSE USING A COMBINATION OF SENSORS
Appliances which do not envisage the SUPER RINSE option combined with a button can enable it through
a sensor combination.
During the selecting phase, touch the two sensors shown in the figure simultaneously for a few seconds until
the related icon lights up. This option also remains enabled during subsequent cycles. To disable it, repeat
the same operation until the related icon is turned off.

No spin
 It eliminates all the spin phases.
 It adds three rinses to the COTTON cycle and one to the SYNTHETIC FABRICS cycle.

TM5-6-7-8
 Modifies the structure of the COTTON – SYNTHETIC FABRICS – DELICATES cycles to obtain good
washing performance in a variable amount of time.

TM2-3-4
 Modifies the structure of the wash phase of the COTTON – SYNTHETIC FABRICS – DELICATES cycles
by half a load.

TM1
 Modifies the structure of the wash phase of the COTTONS – SYNTHETICS – DELICATES cycles by 1 Kg
of laundry.

Delayed start time
 Adds a pause before the start of the programme. The delay time is shown on the three digit display.
 During the programme selection phase, a delayed start can be selected, from 30' to 20 hours (30'
  
90' 3h...
2h
decreases one minute at a time.
 To start the cycle immediately after the countdown to the delayed start has already begun:
press the Start/Pause button, cancel the delay time by pressing the relevant button, then press
Start/Pause again.
Technical Support - MDM
TC4
 
20h 0h) and the time is shown on the display; during the last one, the time
38/97
TC3

60'
599 76 11-68 Rev. 01