Description Of Options - Electrolux EWM1000 Service Manual

4.3 Description of options

•
Night cycle:
→ Eliminates all spin phases and adds three rinses in COTTON cycles and one rinse in SYNTHETICS
cycles.
→ Stops the appliance with water in the tub before the final rinse.
→ Switches off the buzzer (if featured and configured).
→ To drain the water, reset the programme and then select a drain or spin cycle.
•
Pre-wash:
→ Adds a pre-wash phase at the start of the cycle with 30°C water (or cold, if selected).
→ In COTTON and SYNTHETICS cycles, performs a short spin before beginning the washing phase.
→ This option cannot be selected for WOOL and HAND WASH cycles.
•
Stains:
→ Adds a 5-minute motor movement phase after 40°C water heating phase.
→ Ducts water to the pre-wash/stains compartment in order to introduce the special stain remover.
→ This option cannot be selected for DELICATES, WOOL and HAND WASH cycles.
•
Short (daily):
→ Modifies the structure of the wash phase in COTTON and SYNTHETICS programmes in order to obtain
good washing performance with a very short cycle (optimized for small loads).
•
Very short:
→ Modifies the structure of COTTON, SYNTHETICS and DELICATES programmes in order to obtain very
short washing times (optimized for small or slightly dirty loads).
→ Reduces the number of rinses (one less).
→ Increases the water level in the remaining two rinses.
•
Economy / Energy label:
→ Modifies the structure of COTTON 40-60 and SYNTHETICS 50/60 programmes in order to reduce
energy consumption.
→ Reduces the washing temperature.
→ Increases the duration of the wash phase.
•
Extra rinse:
→ Adds two rinses in COTTON, SYNTHETICS and DELICATES cycles.
→ In COTTON cycles, performs only two intermediate 450 rpm-spin cycles. (CSR)
•
Bleach:
→ Ducts water through the bleach compartment at the beginning of the first rinse in COTTON cycles.
•
Half load:
→ Eliminates one rinse in COTTON programmes.
•
Easy-iron:
→ In COTTON programmes:
- adds three rinses
- eliminates the intermediate spin cycles
- performs one impulse spin phase
- extends to 5 minutes the "untangling" phase after the spin cycle.
→ In SYNTHETICS programmes:
reduces the heating temperature in 50/60° cycles to 40°C
-
increases the washing time
-
- extends the cooling phase at the end of the washing phase
- adds one rinse
- extends to 5 minutes the "untangling" phase after the spin cycle.
SOI/DT 2002-07 eb
12
599 35 36-69