Electrolux EWF1284EDW Service Manual page 14

Display
The display is produced by a black film with transparent, silk-screen printed symbols, which are lit by yellow
LEDs when activated.
The display shows the following information:
 - Duration of the washing programme, which appears after it has
been selected. This time corresponds to the time required for the
maximum wash load for each type of programme. If an option is
selected/deselected, the time is automatically updated. After the
programme has started, the time decreases (and is updated) minute
by minute.
 - End of the programme is indicated by a permanently lit zero
(when the door can be opened).
 - Appliance stopped with water in the tub, after programmes with
the RINSE HOLD option. This is displayed by a permanently lit zero.
The symbol indicating the door remains on and the LED of the
START/PAUSE sensor is turned off. The washing machine continues
to operate, rotating the drum once every 2 minutes.
 - Delayed start:
Selected using the relative sensor, every time the delayed time is
pressed, it increases and is simultaneously shown on the display.
 Up to 90 minutes the increases are of 30 minutes ( 30 min. 
60 min.  90 min.)
 From 2÷20 hours the increases are of 1 hour (2 hrs.  3 hrs.... 
20 hrs.  0 hrs.).
In order to reset the delay time, reach the maximum delay time
(20 hours) and the next time the sensor is pressed the delay time
is cancelled.
Once the delay time has been set, after 3'' of no sensor being touched, the display will once again show
the programme's duration time. Press the sensor once to view the set delay time. After starting the cycle
the display shows the delay time count down.
The icon and LED near the silk-screen printed symbol stay on, for the entire selection and delay
phase, to show that the function is active.
During the last hour, the time decreases minute by minute.
To cancel the delayed start time, after the cycle has started, pause the washing machine using the related
sensor and cancel the option.
 - Padlock:
When lit, it indicates that all the sensors are disabled to prevent
children from altering, starting or pausing the cycle.
To disable this function, a sensor combination needs to be pressed,
which can be printed on the control panel or described in the
instruction manual.
Technical Support - MDM
14/97
599 76 11-68 Rev. 01