Bellow Seal; Blade - Electrolux EWF1284EDW Service Manual

To reassemble the door safety interlock, repeat the same tasks in reverse order.
Before tightening the screws to secure the door safety interlock to the front
panel, make sure the flange is positioned properly on the outside as
indicated by the arrows.
Tighten the screws at a torque of 2.5 Nm.

14.3.3 Bellow seal

Remove the iron ring securing the bellow seal to the unit.
Release the bellows seal from the front panel.
Take the seal out of the welded tub.
(Take care as the seal is held in position by a snap ring.)
When reassembling the seal.
Lubricate with liquid soap the part where the tub is inserted.
Make sure the references are aligned.
Reassemble the snap ring between the door bellows seal and the tub.
Reassemble the iron ring between the door bellow seal and the cabinet.

14.3.4 Blade

This blade is secured to the drum with slides and secured with blades
carved into the drum.
To remove it from the drum:
Insert a flat-tip screwdriver into the third slot (start counting from the end)
as shown in the figure.
Insert the screwdriver with the handle tilted towards the left.
Push the right-hand tab down.
84/97
Technical Support - MDM 599 76 11-68 Rev. 01