Electrolux EWF1284EDW Service Manual page 66

Alarm Description
Drain filter clogged
EF1
(drain phase too long)
Overdosing of detergent
EF2
(too much foam during drain
phases)
EF3 Aqua control system intervention
Water fill pressure too low, no
signal from flow meter and
EF4
electronically controlled valve
is open
EF5
Unbalanced load
EF6
Reset
Power supply frequency of
EH1
appliance outside the limits
EH2
Supply voltage too high
EH3 Supply voltage too low
Technical Support - MDM
Possible fault
Drain filter clogged/dirty;
Drain hose blocked/kinked/too high.
Excessive detergent dosing; Drain hose kinked/blocked;
Drain filter clogged/dirty.
Water leaks onto base frame; Aqua control system faulty;
Drain pump coil overheating/broken.
Tap closed, water fill pressure too low.
Final spin phases skipped.
If it continues, replace the main board.
Problem with the power supply network (incorrect/disturbed);
Main PCB faulty.
Problem with the power supply network (incorrect/disturbed);
Main PCB faulty.
Problem with the power supply network (incorrect/disturbed);
Main PCB faulty.
66/97
Machine status/action
Warning displayed at the end of cycle
Warning displayed after 5 attempts
or by the specific LED
Appliance drains
----------------
----------------
No action to be taken
Wait for nominal
frequency conditions
Wait for nominal
voltage conditions
Wait for nominal
voltage conditions
Reset
START/RESET
RESET
ON/OFF RESET
RESET
START/RESET
----------------
ON/OFF
ON/OFF
ON/OFF
599 76 11-68 Rev. 01