Maxair CAPR User Instructions page 90

NOTE
!
All procedures are the same for the "PB" Hood as for the "PW" Hood; only the "PW" ML version is shown. The "PW"
Hood body material is essentially a heavier weight, non-breathable alternative to the "PB" version.
Don Battery, Belt, Helmet and Hood
1. Remove all System Components from their packaging, ensure they are ready for use, and lay them on a clean counter with labels facing you.
2. Assemble the Battery onto a double layer of Belt. Place the
top edge of the Belt under the Battery Clip, fully under and
up to the Clip top, so the Clip Detent rests on the Clip Base
and NOT the Belt. Place the belt comfortably around the
waist with the battery near the side-back of the right hip.
5. Position Helmet on 6. Turn Ratchet Knob clock-
head with front wise as tight as comfortable
Headband within 1/2 to secure Helmet to Head
inch of eyebrows. for all anticipated activities.
10. Attach (snap) other Hood-Lens
mounting hole to other Helmet
side mounting post.
14. Holding the Helmet securely on
head, grasp back bottom of Hood
Body and pull up, over, and down
below Helmet in back.
Page 90 P/N 03521015 Rev Q
3. Connect the Helmet Power Cord to the
7. Gently pull Cuff and
Flappers away from
Lens to ensure they are
not stuck together.
11. Pull Cuff down and back under
chin, then insert fingers between
face and Cuff and gently pull Cuff
and Flapper so Flappers point
towards the temples (both sides).
15. Continuing process of 14, pull
Hood all the way down so that
Hood Filter (top) is fully down on
Helmet.
Battery. Push the Power Cord Connector
into the Battery Receptacle until the Secure
Lock audibly clicks. (Do NOT hold down the
Black Secure Lock Button.)
8. Attach (snap) center
Hood-Lens mounting
hole over Helmet cen-
ter mounting post.
12. Slide index or first finger be-
tween Cuff and face from chin
to the temples, both sides, to
check there is slight tension
between cuff and face.
16. Ensure all Filter (top) folds above front of
Lens (A) are removed by holding Hood body
in front below Lens (B) and in back below Filter
(C) and pulling down firmly in back.
4. Turn the Headband Ratchet
Knob counterclockwise to
loosen Headband for ease
of donning Helmet.
9. Attach (snap) one side
Hood-Lens mounting hole
to respective Helmet side
mounting post.
!
CAUTION
If condition in 12. is
not achieved, switch
to the other size Hood
(SM version) before
proceeding.
13. Don the appropriate
body covering PPE for
your application per the
manufacturers' instruc-
tions.
C
A
B