Maxair CAPR User Instructions page 66

Doffing the System: Alternative B
1. With the System mounted on
head, remove the DLC from
the Helmet. Dispose the DLC
according to your institution's
protocol for contaminated waste.
4. Disconnect the Helmet Power
Cord from the Battery - push
the Secure Connection Button
down, pull Cord Connector out,
release the Button.
7. The entire CAPR System may be
decontaminated, cleaned and/or stored
at this time.
Page 66 P/N 03521015 Rev Q
2. Loosen the rear Headband Adjustment
Knob by turning it counterclockwise
5. Disconnect the Battery Belt from
around the waist by un-snapping the
buckle.
8. If desired, all components of the CAPR System may be
disassembled and each component decontaminated, cleaned
and/or stored at this time.
3. Hold the front top of the Helmet in
one hand and with the other hand on
the Adjustment Knob; lift the Helmet
up and off the head.
6. With the Charger connected
to the mains wall power,
connect the Charger Cord to
the Battery. Push the Charger
Cord Connector into the Battery
Receptacle until it is fully seated.
WARNING
Refer to Section 9, page 43, Instructions For
Use: Charger, for details on proper use of
chargers and for charging batteries.